Tuesday, 5 February 2019
Default Routing (only for 2 Network)
Default Routing (only for 2 Network)
1 1.Default Routing:
-It is use for packet send in single destination
2.Default
Routing Support only one network
3.In Default
routing we can add outgoing port information, do not add destination network
and subnet mask.
Diagram
Step 1: - Basic
Configuration
Go to first router
Router>enable
Router#configure terminal
Router(config)#int s0/0
Router(config-if)#ip address 192.168.30.1 255.255.255.0
Router(config-if)#no shut
Router(config-if)#exit
Router(config)#int f0/0
Router(config-if)#ip address 192.168.10.1 255.255.255.0
Router(config-if)#no shutdown
Router(config-if)# exit
Go to Second router
Router>enable
Router#configure terminal
Router(config)#int s0/0
Router(config-if)#ip address 192.168.30.2 255.255.255.0
Router(config-if)#no shut
Router(config-if)#exit
Router(config)#int f0/0
Router(config-if)#ip address 192.168.20.1 255.255.255.0
Router(config-if)#no shutdown
Router(config-if)# exit
Step 2
Clock rate
1 In Default
Routing clock rate set in only one router
Command
Go to first router
Router>enable
Router#configure terminal
Router(config)#int s0/0
Router(config-if)#clock rate 64000
Router(config-if)#Exit
Step 3
Routing
Router 1=> go to config Terminal-à ip route 0.0.0.0 0.0.0.0
192.168.30.2
Example
Router#configure terminal
Router(config)#ip route 0.0.0.0 0.0.0.0 192.168.30.2
Router 2=> go to config Terminal-à ip route 0.0.0.0 0.0.0.0
192.168.30.1
Example
Router#configure terminal
Router(config)#ip route 0.0.0.0 0.0.0.0 192.168.30.1
Now Check
Send Packet from One Network To another
---------------END-------------------
Now Check
Send Packet from One Network To another
---------------END-------------------
Subscribe to:
Post Comments
(
Atom
)
No comments :
Post a Comment